Open topic with navigation
Configuring Novell-based guests after restoring
- SSH to the virtual guest.
- Confirm that the network scripts are not configured to rely on a hard-coded MAC address. If they are, manually change the scripts to match your virtual server’s NIC.
- Review /boot/grub/device.map to confirm that the configuration matches your virtual hardware. Pay special attention if you are restoring from an IDE or PATA-based host to a SCSI-based virtual server, because the naming conventions between the hardware types are different. For example, if you are restoring from a PATA-based physical server to a virtual server, you will need to change the mapping to read sda instead of hda.
- Review /etc/fstab and make any necessary adjustments to the file system table to ensure that the file accurately reflects the proper block device location of each file system. Again, be sure to account for differences between PATA and SCSI, as appropriate.
- Compare the INITRD_MODULES line from your physical and virtual kernel configuration files (/etc/sysconfig/kernel and /etc/sysconfig/kernel.pre-migration), adding any declared modules in your pre-restoration file to the current. At a minimum, the pcnet32 and mpt* entries must be added to ensure system functionality post-restoration.
- Run the mkinitrd command to rebuild the kernel's ramdisk to support the hardware changes.
- Reconfigure and reinstall the grub bootloader via yast2. Use the yast2 bootloader command, and inspect the properties of each boot menu option to ensure that any drive declarations are up-to-date with your new virtual hardware, and that the correct and matching boot image and kernels are defined.
- Reboot the virtual server into single user mode, by adding single to the boot options line, and watch for any file system or other error messages. If the server is running X Windows, you will need to install the VMware Tools package and configure them for use with X Windows. See your VMware documentation for installation information.
- Reboot the server into full user mode.